IE4000 Auto-Image and Auto-Config not working together (CISCO PNP Issue??)
I have been trying to get a number of IE4000s to utilize both auto-image and auto-config in one shot. I can get them to work on their own but when I try to get Auto-image to work with auto-config only the imaging works. I have to shut off the auto-image dhcp parameters to get the image to download during a reload. I think it may be because the switch has an internet connection and it keeps connecting to cisco's pnp service. How do I stop the PNP service this and would this cause the auto-config to only work when auto-image is not invoked? See the log below:
if by auto-image, are asking for the IE4000 to download the IOS image from the server? if yes, then this is not a recommended practice. its best to use 'archive download-sw ... <fn.tar>' to install IOS images to the IE4000. this is because the IE4000 release has additional files associated with it besides the IOS binary. these files are ncessary fo rthe IE4000 to function properly. the most important file is the FPGA file. there's a tight 1-1 mapping between the FPGA file and the IOS binary for a given release. they must be installed together.
PNP is pesky. as soon as there's running configuration, it will shut itself off. should anyway.
From low data rate wireless, such as low-power-wide area technologies that are designed for small devices running on batteries, to the emergence of high data rate wireless technologies, such as 5G, and Wi-Fi 6, decision makers and network experts ...
This how-to is a step-by-step guide to create and configure an app for IOx on IE3400 which can monitor traffic flowing through the switch.
IOx on IE3400 offers the capability to send a copy of any traffic flowing through the switch to a cust...
This how-to is a step-by-step guide to create a simple docker container which can run on IOx on IE3400.
Unlike Catalyst 9300, which has a x86 (more specifically: x86-64) compatible CPU, IE3400 runs IOx apps on an ARM Cortex-A53 CPU. The...