Technical issue/doubts on 2960X-24PS-L Ethernet Switch
Dear CISCO Team,
We are communicating W5500 ETHERNET IC through CISCO Ethernet Switch 2960X-24PS-L in our IOT device for data transmission. But, Ethernet is not working with different Switch Configuration at all the time. The observations for Ethernet working with different switch configuration is listed in the Document Attached.
Kindly Please go through the document and let us know what could be the problem for which Ethernet working behavior is so with different configuration?
Also, please confirm which switch configuration should I set and What should I need to do/check in my code for proper working?
you posted this query in the industrial networking community. the C2960 is not a product under industrial networking. C2960 is an Enterprise product. you should try posting your query there
I can tell you this: with the information you've provided, they will not be able to help trouble shoot your problem. you're providing your observations, and what is really needed it actual output from the C2960 CLI.
for each trial run you need to provide along with your observations
- show interface <gi1/0/x>
- show power inline <gi1/0/x> (if not using PoE then never mind)
Quick Reference: Cisco IE5000 IRIG-B Support
Cisco Industrial Ethernet 5000 series switches (IE 5000) have integrated hardware support for external time sources: GPS antenna and IRIG-B (analog and digital timing I/O) interfaces. These interfaces are compl...
This document helps the user deploy Cisco Edge Intelligence on Cisco Gateways, configure the gateways to support EI in IOX and assist the user in building an environment to demo the capabilities of EI for both monitoring Modbus (TCP or RTU) and OPC-UA de...
From low data rate wireless, such as low-power-wide area technologies that are designed for small devices running on batteries, to the emergence of high data rate wireless technologies, such as 5G, and Wi-Fi 6, decision makers and network experts ...