Haven't gotten much response to my other posts, hoping I get some about this.
For those using load balancing, do you name your DSP the same on both servers? I was trying to see if there were pros and cons to naming them different or the same (or if you can't name them the same).
We have them named different, one is TesDevCM1 and the other is TesDevCM2. This makes it easier to troubleshoot and know where someone is connected BUT I realize that this is not good when you are trying to truly utilize loadbalancing for example for Transporter and TESCmmandline as this forces you to bound these apps to a specific CM.
Just wanted to see if there were opinions out there. (Made my post shorter, hopefully someone will respond ^_^)
Cisco launched their solution for hybrid cloud solution for the Microsoft Azure public cloud back in September of 2017. Since that time, Cisco has enjoyed great success with installations around the world from Poland to Australia and many points in ...
NoticeThis is not an official guide, just something I've been testing to help during those "difficult" situations. All works here are my own!GoalsThere are some situations where we need to load an image onto a Nexus switch (or other network devices ...
I was playing a little with some show commands on ACI and i found that on leaves there are VXLAN tunnels also towards the APIC (10.0.0.1 in the figure); i was wondering why there should be these tunnels? APIC is using VLAN 3967 as infrastructure VLAN, and...