Trying to lower System Queue to Zero

[Michelle Morris]

                  I am running 5.3.1.366 in several environments (Dev, Test, Prod)  When I try to lower the system queue to 0 so that no new jobs launch, my entry is overwritten and goes back to the previous set number.  Even if I set it to 1 it goes back to the previous number.  This is happening on all 3 masters, so I don't think it is a quirk with my install.  In earlier versions of 5.3.1 I was able to do this.

Has anyone else experienced this?  In dev, I stopped Tidal and snuck into the database and edited the limit (definitely not supported by Tidal, but wanted to see what would happen.)  My zero setting stayed 0.

I haven't called Tidal Support about this yet...wondering if it is just me.

Thanks!

Michelle

[Michael Whiteley]

Did someone write a system event to trap the change, and then performed some action to reset?

Sent from Cisco Technical Support iPad App

[Michelle Morris]

Have found system events that send email or snmp traps when the limit is lowered, but no actions that reset the value.

Michelle

[jeff.hamway01]

Bump.  Is there a event to trigger the system queue to zero automatically in TES? this would be very helpful.