cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
242
Views
0
Helpful
1
Replies
Highlighted
Cisco Employee

Firepower 6.2 Packet Tracer error

Just trying to run a packet tracer on my Firepower device, and I do get output when I use the "diagnostic" interface.  However, if I try to use any of the actual interfaces, I get the following error:

"An error occured while executing the Packet Tracer command."  

Not very informative.  Anyone else seen this?  How to troubleshoot?  Thanks!

Everyone's tags (1)
1 REPLY 1
Hall of Fame Guru

Have you upgraded your

Have you upgraded your sensors to Release 6.2?

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here
This widget could not be displayed.