06-01-2018 05:36 AM - edited 02-21-2020 07:50 AM
Hi,
I have a Firepower 7010 with no power lead. What type of power cable do I need to search for online?
I searched the data sheets on cisco.com, but the power cord stipulated is not correct (IEC C13/14). I have attached a picture of the interface I require a power cable for.
Grateful for any help! Thanks.
Solved! Go to Solution.
06-02-2018 01:26 AM
It's a part called "FP-PWR-BRICK=". The C13/C14 goes from the mains supply to the "brick" itself which has the built-in AC-DC converter.
They are still sold by Cisco. List price is US$300. You may find them from 3rd party resellers as well.
06-02-2018 01:26 AM
It's a part called "FP-PWR-BRICK=". The C13/C14 goes from the mains supply to the "brick" itself which has the built-in AC-DC converter.
They are still sold by Cisco. List price is US$300. You may find them from 3rd party resellers as well.
06-04-2018 02:19 AM
04-14-2019 06:33 PM
Hi Marvin. I too have this problem, no power supply. I do have a plug that fits the power socket in my Firepower 7030 but is the wrong voltage. Would you happen to know what the pinout is for the FP-PWR-BRICK= is as I would be able to adapt another 12V power supply to suit.
04-15-2019 08:58 PM
Sorry but I don't have the pinout information. As far as I can tell it's not published in any Cisco specification.
04-15-2019 09:20 PM
Hi Marvin, Thanks anyway, I didn't think it would have been published. What I did though was put my multimeter between the black wire pins on the feed to the HDD and pinned out the connector. I found that the bottom two pins were directly connected and that the top two pins weren't. The top two are then the +12vdc feed. I hooked it up to my bench power supply, gave it 12vdc and it worked. Saved myself $250+.
04-15-2019 11:20 PM
Nice work! Thanks for sharing your solution.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: