cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
1236
Views
0
Helpful
3
Replies
Participant

FirePOWER IPS Inline Port Channel

Hi All,

 

I need to install a Cisco FTD 2100 series appliance to sit inline between our Cisco ASA firewall and LAN switch. The Cisco ASA is connected to the LAN switch using 2 x 1GbE interfaces that are bundled in a port channel.

 

To ensure that the FTD inspects traffic over both ASA port channel member interfaces, I'm assuming that I need to configure 4 inline interfaces on the FTD (one pair for each port-channel member link) and then place them all in the same inline set? Could someone please confirm?

3 REPLIES 3
Participant

Re: FirePOWER IPS Inline Port Channel

Any ideas anyone?
Highlighted

Re: FirePOWER IPS Inline Port Channel

Hi Will,

 

 I have the same doubt as you.
Did you get an answer to your question?

 

Regards

Enthusiast

Re: FirePOWER IPS Inline Port Channel

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here