cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1555
Views
0
Helpful
1
Replies

Firepower Re-image in Active/Standby ASA

NETAD
Level 4
Level 4

Hello, can you verify the steps for re-imaging the firepower modules on ASA in active/standby?

 

There's no worries for being without the IPS for couple hours so I'm planning on doing the following:

on the primary:

1-Copy the boot image to  flash

2-shutdown and uninstall the SFR module

3-sw-module module sfr recover configure image disk0:/asasfr-5500x-boot-6.2.2-3.img

4-sw-module module sfr recover boot 

5-session sfr console

6-Configure network information and ftp the .pkg file

7-system install ftp://cisco:cisco@192.168.2.14/asasfr-sys-6.2.2-81.pkg

8-Add to FMC

9-failover and re-do all the steps above

10-failback

 

Thanks

 

1 Accepted Solution

Accepted Solutions

yogdhanu
Cisco Employee
Cisco Employee

Hi There,

 

All of the steps looks good assuming the primary ASA would be standby at that time.

Once its finished, you would be failing back to primary (active) and do same steps on the secondary (now standby) ASA.

 

Hope it helps,

Yogesh

View solution in original post

1 Reply 1

yogdhanu
Cisco Employee
Cisco Employee

Hi There,

 

All of the steps looks good assuming the primary ASA would be standby at that time.

Once its finished, you would be failing back to primary (active) and do same steps on the secondary (now standby) ASA.

 

Hope it helps,

Yogesh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: