cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
202
Views
5
Helpful
3
Replies
Beginner

FMC "deployment failed due to configuration error"

Dear Community

 

i'm facing the following error when i deploy the Access Control policy

one of the 5525x firepower succeed while the other fail.

the FMC is a virtual appliance.

even when i deploy a basic any to any policy

image.png

Everyone's tags (2)
3 REPLIES 3
VIP Mentor

Re: FMC "deployment failed due to configuration error"

I also faced this problem a couple of times with some ASAs with Firepower module and had TAC-cases open for that. The result typically was to just reinstall the module and reapply the policy. Probably not an answer you hoped for, but at least it got me out of these situations.

Beginner

Re: FMC "deployment failed due to configuration error"

thank you, i spent allot of time troubleshooting this.

i will just do this.

Highlighted

Re: FMC "deployment failed due to configuration error"

I have the same issue on some asa5525+fpr and I found that reloading the device (reload command on asa) solves the issue for some weeks.

Not a good solution, but better than reimaging.

Release is 6.2.3.11, soon I'll move to 6.4 and see if the issue disappear.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here