05-24-2012 06:01 PM - edited 03-10-2019 05:41 AM
Hi Netpros,
I have a situation where I need to bypass any inspection between two hosts. I currenlty have the IDSM-2 performing in-line VLAN pair. From reasons I can't currently detail I don't have access to the web interface and therefore need to perform this from the command line. Basically any comunication from host A ->to host B and from host B-> to host A needs NOT to be inspected at all as traffic traverses the IDSM-2. Your assistance would be much appreciated.
Also, is there any way to clear the mac address table from the IDMS-2 using the CLI ?
05-25-2012 03:00 PM
There is no way to configure the IDSM to accomplish this in an inline fashion. In a promiscuous configuration, you could use a VACL to specify what specific traffic should be redirected to the module. There is an open feature enhancement for this.
05-29-2012 05:37 AM
Thanks
Sent from Cisco Technical Support iPad App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: