IPS 4240 boot problem

[wowwangccie]

Hi ,all

ips 4240 ， boot  screen  display  this information again and again ， it’s not work when i try to copy a new image to flash card from tftp ， test the flash card is ok ，so what should i do to fix it

CISCO SYSTEMS

Embedded BIOS Version 1.0(11)2 01/25/06 13:21:26.17

Low Memory: 631 KB

High Memory: 2048 MB

PCI Device Table.

Bus Dev Func VendID DevID Class              Irq

00  00  00   8086   2578  Host Bridge       

00  01  00   8086   2579  PCI-to-PCI Bridge 

00  03  00   8086   257B  PCI-to-PCI Bridge 

00  1C  00   8086   25AE  PCI-to-PCI Bridge 

00  1D  00   8086   25A9  Serial Bus         11

00  1D  01   8086   25AA  Serial Bus         10

00  1D  04   8086   25AB  System            

00  1D  05   8086   25AC  IRQ Controller    

00  1D  07   8086   25AD  Serial Bus         9

00  1E  00   8086   244E  PCI-to-PCI Bridge 

00  1F  00   8086   25A1  ISA Bridge        

00  1F  02   8086   25A3  IDE Controller     11

00  1F  03   8086   25A4  Serial Bus         5

00  1F  05   8086   25A6  Audio              5

02  01  00   8086   1075  Ethernet           11

03  01  00   177D   0003  Encrypt/Decrypt    9

03  02  00   8086   1079  Ethernet           9

03  02  01   8086   1079  Ethernet           9

03  03  00   8086   1079  Ethernet           9

03  03  01   8086   1079  Ethernet           9

04  02  00   8086   1209  Ethernet           11

04  03  00   8086   1209  Ethernet           5

Evaluating BIOS Options ...

Launch BIOS Extension to setup ROMMON

Cisco Systems ROMMON Version (1.0(11)2) #0: Thu Jan 26 10:43:08 PST 2006

Platform IPS-4240-K9

Use BREAK or ESC to interrupt boot.

Use SPACE to begin boot immediately.

Launching BootLoader...

Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /

Error 15: File not found

unable to boot an image

Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /

Error 15: File not found

unable to boot an image

Failsafe booting engaged.

Default configuration file contains 1 entry.

Searching / for images to boot.

No images in /

Error 15: File not found

unable to boot an image

Booting system, please wait...

[gaurash2]

The issue could be due to the flash not getting detected during boot up. Please contact Cisco TAC to report the issue.

As a workaround you might want to try this.

1. Hard reboot ( power cycle)  the device

2.  Enter the Rommon mode by interrupting boot sequence.

3. Reimage the device.

Let me know if this works.