LACP through Appliance 8350

[Earl Granger IV]

Hi guys,

My current configuration which I need to validate is an ASA port-channeled to the core.  I am placing the appliance Inline.  I have 1 inline set with 2 interface pairs.  One set of interface pairs are for the Appliance towards the firewall and the other interface pairs are from the appliance to the core.  All for interfaces are under one inline set.  However, the port-channel between the ASA and the Core switch is not forming.  

Is there an issue with the appliance passing LACP packets or my configuration is incorrect?

Thanks

[Jetsy Mathew]

Hello Earl,

Could you please refer the following link and check if all the confis are correct or not.

http://www.cisco.com/c/en/us/td/docs/security/firesight/541/user-guide/FireSIGHT-System-UserGuide-v5401/LAG-Interfaces.html

One more helpful link :-

http://www.cisco.com/c/en/us/support/docs/security/sourcefire-firepower-8000-series-appliances/117897-cinfig-sourcefire-00.html

Even after referring this if you think all the configs are correct then we need a troubleshoot file from the device to verify the configs.

Rate if this answer helps you.

Regards

Jetsy