03-07-2013 11:22 PM - edited 03-10-2019 05:54 AM
Hi all,
I 've been upgrading our ASA 55402 with SSM-20 modules.
Upgrade of one module from version 7.0(7)E4 to to 7.1(6)E4 went just fine.
However the second one returned the following error when trying to upgrade the image and recovery partition:
- cisco ips Upgrade cancelled because another upgrade or downgrade is in progress
The firewall on which i intended to do the upgrade was the passive one.
Firmware ASA: v9.1.1.
Searched the Internet and this forum.
Anyone ran into this?
Thanx
Jaap
Solved! Go to Solution.
03-11-2013 09:42 AM
"hw-module module 1 reset" It won't cause any issues at all.
03-08-2013 11:36 AM
Reload the module.
03-11-2013 07:24 AM
From the ASA CLI
hw-module module 1 reload ?
This will not kill the present image file and/or configuration of the IPS module?
Just to be sure
Thanx Jaap
03-11-2013 09:42 AM
"hw-module module 1 reset" It won't cause any issues at all.
03-13-2013 01:05 AM
Hallo jocamare,
Did a reset of the module.
Upgrade was then possible again.
No issues as you said.
Thanx !
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: