cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
173
Views
0
Helpful
2
Replies
dtom
Beginner

3845 Call-Manager-Fallback

We are running IOS ADVENTERPRISEK9-M ver 15.1(4)10 on a Cisco 3845.  We tried to enter command for call-manager-fallback but the commands are not accepted.  Here is what we normally see:

er-router#conf t

er-router(config)#call-manager-fallback

er-router(config-cm-fallback)#

However, on this particular router we see the following:

er-route2r#conf t

er-router2(config)#call-manager-fallback

er-router2(config)#

Any thoughts here?

1 ACCEPTED SOLUTION

Accepted Solutions
Chakshu Piplani
Cisco Employee

Does both the routers have same memory, features like call-manager-fallback requires the apt amount of memory as per the IOS loaded.

Regards,

Chakshu

View solution in original post

2 REPLIES 2
Chakshu Piplani
Cisco Employee

Does both the routers have same memory, features like call-manager-fallback requires the apt amount of memory as per the IOS loaded.

Regards,

Chakshu

View solution in original post

That was it.  The router that did not work needed more memory added.

Content for Community-Ad

Spotlight Awards 2021