cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

428
Views
0
Helpful
1
Replies
jameskuder
Beginner

7915 will not load

I have connected my 7915 add-on modules to my 7962G. They both have power. I have the proper load statement under telephony-service. When I plug it in, all of the buttons stay lit and are orange. They never go past the Cisco Logo. The phone is up as it should be.

1 ACCEPTED SOLUTION

Accepted Solutions
Logan Gaffney
Beginner

I assume you have the add-on defined under the ephone (if not please do so).

Then please issue the following:

conf t

telephony-service

no cre cnf

cre cnf

Reset the 7915

View solution in original post

1 REPLY 1
Logan Gaffney
Beginner

I assume you have the add-on defined under the ephone (if not please do so).

Then please issue the following:

conf t

telephony-service

no cre cnf

cre cnf

Reset the 7915

View solution in original post

Create
Recognize Your Peers
Content for Community-Ad