cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
535
Views
0
Helpful
1
Replies

7915 will not load

jameskuder
Level 1
Level 1

I have connected my 7915 add-on modules to my 7962G. They both have power. I have the proper load statement under telephony-service. When I plug it in, all of the buttons stay lit and are orange. They never go past the Cisco Logo. The phone is up as it should be.

1 Accepted Solution

Accepted Solutions

Logan Gaffney
Level 1
Level 1

I assume you have the add-on defined under the ephone (if not please do so).

Then please issue the following:

conf t

telephony-service

no cre cnf

cre cnf

Reset the 7915

View solution in original post

1 Reply 1

Logan Gaffney
Level 1
Level 1

I assume you have the add-on defined under the ephone (if not please do so).

Then please issue the following:

conf t

telephony-service

no cre cnf

cre cnf

Reset the 7915