We have an Aironet 1250 and a few 7921G wireless IP phones.
We recently upgrade/migrated to CUCM 188.8.131.52 from 7.0(1)
Everything has gone pretty smooth except our 7921G phones constantly drop. They display "Locating Network Services" and then connection failed. They have firmare version CP7921G-184.108.40.206.LOADS that came with CUCM 220.127.116.11 (I'm guessing).
I found another post that said this firmware needed QoS enabled on the access point - we didn't initially have QoS enabled on the AP, but I have enabled for the Voice VLAN and it hasn't made a difference.
hi Team, we are planning to deploy Multi-Factor Authentication for Jabber. The main requirement is to use MFA over internet (MRA).Is it possible to deploy MFA just for MRA and don't touch impact any on-prem existing setup?Can someone please guide on ...
Looking to expand your professional network? Interested in gaining an edge with exclusive technology insights? Engage with Cisco experts, share feedback on products and connect with peers from across the globe. Cisco Champion 2021 applications are open fo...
UCCX does not natively protect HTTP Triggers.
I wanted to come up with a solution to handle HTTP cookie based authentication.
There is a zip file for this project attached to this article. It was written on UCCX 12.5...
CUCM can backup the manually or have sehchduler to backup the configuration and historical reports from the server diester recovery systemStep 1. Navigate to CUCM > Disaster Recovery System > Backup > Manual Backup as shown in the...