244
Views
0
Helpful
0
Replies
7941 IP Phone - All LEDs remain lit while attempting to boot
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-11-2014 11:23 AM - edited 03-17-2019 01:18 AM
This phone seems to never get to the point where it even begins to load, when power is given through ethernet cable, all LED's remain lit and nothing else occurs. Attempted factory reset, no change - holding down the # key didn't seem to register, all LEDs remain lit and no sign that the signal was received.
I've searched quite a bit online - any help would be much appreciated. I don't believe this to be related to which version of UCM as the phone never attempts to load, screen stays blank with all LEDS lit.
Labels:
- Labels:
-
IP Phone and Accessories
0 Replies 0
