cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
292
Views
0
Helpful
3
Replies

7961GE Hunt Group ringing name

Whammer275
Level 1
Level 1

Our shop has been exclusively 7961Gs for 7 years now.  We recently purchased some 7961GEs and are noticing that when a phone is part of a Hunt Group, the Hunt Group no longer displays on the inbound call.  On the 7961Gs it would say the From: <Caller> For: <Hunt Group> . 

 

Our Help Desk personnel love the 1Gbit speed, but hate not knowing if the incoming call is for them or the Help Desk.

 

Any help is much appreciated!!

 

Thank you,

 

--Whammer

3 Replies 3

Rob Huffman
Hall of Fame
Hall of Fame

Hi Whammer,

 

I'm guessing the new 7961GE's are running a pre - 9.0 firmware;

 

It sounds like this bug

 

 

CSCth95017 - Configurable parameter on how callingparty is displayed for hunt groups.

 

 

 

 

Description

 

Symptom:

 

As of phone load 9.x and higher, calls to a hunt pilot show the following format for the calling party on the ringing phone.

 

From 'Calling Party Name' for 'hunt pilot DN'

 

i.e.  From John Doe for XXXX

 

The previous format was

 

From 'Calling Party Name' ('Calling Party Number')

 

i.e.  From John Doe (XXX-XXX-XXXX)

 

Need a configurable parameter to change the format to the previous format if the customer desires.

 

Conditions:

 

Occurs on phone loads 9.0(x) and above.

 

Workaround:

 

Downgrade to 8.4.x

 

Details

 

 

1st Found-in:                          (1)

 

8.6(2)

 

More

 

Less

 

Status:

Fixed

 

Last Modified:

Mar 11,2012

 

 

Known Affected Versions:

 

More

 

Less

 

Fixed-in:                          (3)

 

9.0(0.98000.74), 9.0(0.98000.21), 8.6(2.21023.1)

 

More

 

Less

 

 

Product:

Cisco Unified Communications Manager (CallManager)

 

 

Platform:

Dependent

 

 

Severity:

2 - severe

 

Customer Reported:                          (26)

 

 

 

Cheers!

Rob

We are currently running CUCM 8.62, can I upgrade a phone's firmware to 9.X?

Also the phone's current load is SCCP41.8-5-2S, how does that translate to 8.6?

Hi Whammer,

 

The relationship between CUCM version and Firmware version is completely independent so that should not be a problem upgrading the 7961GE's to a 9.x release. The only issue is that you may need to go to 8-5-3 as an interim first step but I think you'll be good to go smiley

 

Cheers!

Rob