08-06-2014 02:11 AM - edited 03-16-2019 11:39 PM
How do you deal with this problem?
It works well after I disabled 'power negotiation' when I use CUCM.
But I didn't find any commend from CUCME.
08-06-2014 02:28 AM
Hi
can you share with us the below output from Cisco switch port which is connected to 9971?.
Switch# show power inline gigabitethernet 2/10 detail | begin LLDP
switch# show power inline gigabitethernet 2/10
Thanks
please rate all useful inormation
08-06-2014 03:24 AM
The switch doesn't support POE. I use one device power all ip phones.
08-06-2014 03:50 AM
Hello
The only bug CSCtf09186 with some 802.3af switches, which results in the Cisco Unified IP Phone 9951 and 9971 unable to negotiate for the additional power required to operate the IP phone's camera.For your case if you use power injector or other device , you shouldn't get any issues. Can you disable "no cdp-enable" and "no lldp tlv-select power-management" under the interface on the switch which connected to your IP phone and test?.
Thanks
please rate all useful information
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: