Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1109
Views
0
Helpful
3
Replies

a question about FXS and FXO attendant DN

baselzind
Level 6
Level 6

‎07-18-2019 05:36 AM

im setting up a MGCP with FXS and FXO , im confused about the  attendant DN , with FXO when i set the attendant DN number , it means this is the extension on cucm any incoming calls on that FXO will ring , but with FXS what does attendant DN do? what happens when u put a certain number there?

Labels:
0 Helpful
3 Replies 3

Brandon Buffin
VIP Alumni
VIP Alumni

‎07-18-2019 08:20 AM

Attendant DN is not applicable to FXS ports. Not sure what version of CUCM you are running. There was a bug for attendant DN showing up for MGCP GS/LS config. If you add as POTS port instead of GroundStart/LoopStart the problem is not present. See the bug below.

 

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCtf22348/?rfs=iqvred

 

Brandon

0 Helpful

baselzind
Level 6
Level 6
In response to Brandon Buffin

‎07-29-2019 04:49 AM

my version is 12.5 , im very confused , should i leave it empty?
0 Helpful

Brandon Buffin
VIP Alumni
VIP Alumni
In response to baselzind

‎07-29-2019 05:58 AM

Yes, leave it blank.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents