04-23-2012 07:49 AM - edited 03-16-2019 10:46 AM
Hi all,
I have added one sip extension on cme. Whenever i dial outsdieby dialing 9, it omits digit 9 and finally i cant recall that number. any Clue?
04-23-2012 07:51 AM
Try
voice service voip
sip
no update caller-id
04-23-2012 09:53 PM
Its not working.
Following is the sip setting
voice service voip
allow-connections sip to sip
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
sip
registrar server
no update-callerid
!
Following is the dial-peer
dial-peer voice 10 pots
trunkgroup FXO
description GSM
destination-pattern 903.........
forward-digits 11
Following is the phone setting
voice register global
mode cme
source-address 192.168.X.X port 5060
max-dn 5
max-pool 5
authenticate register
!
voice register dn 1
number 1234
name test
!
voice register pool 1
id mac 1234.F219.0A2A
number 1 dn 1
username 1234 password 1234
codec g711alaw
04-23-2012 10:16 PM
forward digits is 11, the extension is 12 digits, so it will omit 9 when make outbound call.
04-24-2012 03:46 AM
Zhen Huang wrote:
forward digits is 11, the extension is 12 digits, so it will omit 9 when make outbound call.
I'm afraid that you did not understood OP question.
04-24-2012 09:54 PM
i think its matter of global digit normalization.
04-25-2012 01:19 AM
Hello,
Could see,
dial-peer voice 10 pots
trunkgroup FXO
description GSM
destination-pattern 903.........
forward-digits 11
There are 2 ways to send 9 here
1.
dial-peer voice 10 pots
trunkgroup FXO
description GSM
destination-pattern 903.........
forward-digits 12
2.
dial-peer voice 10 pots
trunkgroup FXO
description GSM
destination-pattern 903.........
forward-digits 11
Prefix 9
Thanks
Siva
Please rate if helps you.
04-25-2012 01:47 AM
Zhen Huang & Sivakumar Shanmugam this is not the matter of sending the digits but to match E.164 dialing pattern.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: