cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
476
Views
0
Helpful
2
Replies

Adding 35x VGs using BAT: MAC Address

conor.maton
Level 1
Level 1

Hello all,

 

I currently have 35x Cisco VG350s racked up in a lap with no configuration enabled. I am looking to prepare adding these to CUCM using the Bulk Adminsitration Tool.

 

After a quick research I understand I need the MAC address of the VG and preceed this with 'SKIGW' as it will communicate via SCCP. However I am unsure how I find the MAC address of the VG350, or if I need to add any preceeding config. Can anybody help pelase?

 

Thank you in advance!

2 Replies 2

conor.maton
Level 1
Level 1
Anyone? What doesn't help is I'm using Loopback0 which doesn't have a MAC address:

sccp local Loopback0

Rejohn Cuares
Level 4
Level 4

This does not answer your question but follow this guides to successfully integrate the VG to CUCM.

https://www.cisco.com/c/en/us/support/docs/voice/skinny-call-control-protocol-sccp/211575-CUCM-Auto-Configuration-for-SCCP-Gateway.html

https://community.cisco.com/t5/collaboration-voice-and-video/stcapp-how-to-configure-fxs-ports-on-cucm/ta-p/3142555
Please rate replies and mark question as "answered" if applicable.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: