I have an ALGO 8180 SIP alerting device which show registered in CUCM but is not working. Can someone share any document/experinece where you got it working.
Please see the attachemnt where it shows as registrerd with the call manager.
I assume you worked thru this document?
Sent from Cisco Technical Support iPad App
I've set the 8180 to both ring and page with not much of an issue (as far as I remember!)
Did you follow this guide: http://www.algosolutions.com/pdf/AN-8180-002.pdf
This device has to configured as a shared line but we were just assigning the extension to the AlGO devie. I created an extension on a phone and then shared it with ALGO 8180 and that worked.
I have a Algo 8180G2 loud ringer and I cannot for the life of me get both loud ringing and paging to work, I followed the instructions everyone listed .algosolutions.com/pdf/AN-8180-002.pdf
I made 2 users in CUCM one for paging and one for loud ringing. But only the extension I have configured in CUCM line 1 DN will work with the Algo unit. I tried as suggested above to set the loud ringer as an extension used by another phone but that doesnt work.
I only get this message:
|Ring #1||Rejected by server.|
Check SIP server address & account credentials.
I found an updated config document on Algo's website. I hope this helps anyone else who finds this thread: