cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
939
Views
0
Helpful
3
Replies

analog phone not registering on VG224

RFC_2549
Beginner
Beginner

Hello,

I have a problem with a VG224 because on the CUCM I added an analog phone to it in a door but it doesn't record it.

Initially the phone (with drectory number 100 for example) was attached to another VG224, so I copied the phone and the line on the new port of the new VG224, I reset the phone and the line but the phone appears (from CUCM) still be registered on the old VG224. What can I do? doing a sh run on the two VG224 configurations do not coincide with those of the CUCM, should they not update automatically when I change something on the CUCM?

Thank you

3 Replies 3

George Sotiropoulos
Cisco Employee
Cisco Employee

Please can you post part of the VG configuration?

Thanks,

George

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

yes, the interested port is 2/13

 

Ystcapp supplementary-services

 port 2/12
fallback-dn 1347
!
!
!

 

so there aren't directory number specified for port 1/13

 

!
voice-port 2/13
timing hookflash-in 110 80
!

 

this is the conf of the voice port interested

 

Thank you!

Please also post the dial peer (stcapp) configuration.

Its likely the dial peer is still configured on the old VG224.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: