cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
440
Views
0
Helpful
1
Replies
CARLO CALABRESE
Beginner

Analog Trunk to Fax Server

I have a Fax server with analog trunks. I need to configure a 2811 to be able to pass 5 digits to it.

Can I do it with a vwic3 4 port fxs/DID?

Can I do it with MGCP?

and where can I find configs or examples of it.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Chris Deren
Hall of Fame Master

Yes, the card should work fine.

Depending on what faxing protocol you are planning on using MGCP may not be the wiesest choice, h323 and SIP both support T.38 version 3 which supposts super G3 speeds with 15.1+ IOS. For T.38 version 0 or passthrough or cisco fax relay  either protocol is fine.

there is plenty of config samples on CCO and this forum, you use the search tools.

HTH, please rate all useful posts!

Chris

View solution in original post

1 REPLY 1
Chris Deren
Hall of Fame Master

Yes, the card should work fine.

Depending on what faxing protocol you are planning on using MGCP may not be the wiesest choice, h323 and SIP both support T.38 version 3 which supposts super G3 speeds with 15.1+ IOS. For T.38 version 0 or passthrough or cisco fax relay  either protocol is fine.

there is plenty of config samples on CCO and this forum, you use the search tools.

HTH, please rate all useful posts!

Chris

Create
Recognize Your Peers
Content for Community-Ad