cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

200
Views
5
Helpful
4
Replies
Beginner

Assigning a FXS Extension to a Hunt Group

Hello,

Basically I have an existing hunt group that consists of all CP-8841 and CP-7965 telephones which use an assigned button to log in and out.  Is it possible to add an analog gateway extension to the group and have it set up to log in and out with an access code?  I keep seeing *3 and #3 listed as access codes for this but where is that assigned?  Is it in the call manager or the gateway or both?

 

Thanks

Dale Shew

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Advisor

Re: Assigning a FXS Extension to a Hunt Group

The identifier is your choice. Most people just label their servers 1 - N, and whichever you one you want to start with.

 

E.g.,

sccp ccm 10.1.1.10 identifier 1 ; pub
sccp ccm 10.1.1.11 identifier 2 ; sub 1
sccp ccm 10.1.1.12 identifier 3 ; sub 2
!
sccp ccm group 1
 associate ccm 3 priority 1 ; sub 2 first
 associate ccm 2 priority 2 ; sub 1 second
 associate ccm 1 priority 3 ; pub third
!

Anthony Holloway

If you found this post helpful, please consider clicking that helpful button!

And for a limited time, by marking helpful posts, you're also helping Doctors Without Borders

View solution in original post

4 REPLIES 4
Hall of Fame Cisco Employee

Re: Assigning a FXS Extension to a Hunt Group

Highlighted
Beginner

Re: Assigning a FXS Extension to a Hunt Group

Thanks Jamie,

I've found where I have to assign the SCCP parameters in my VG-310 to get this working but I'm not sure where to find the Call Manager identifier number.  Do you know where that is?

 

Dale 

Hall of Fame Cisco Employee

Re: Assigning a FXS Extension to a Hunt Group

You don't configure anything on CUCM for this.

HTH

java

if this helps, please rate
VIP Advisor

Re: Assigning a FXS Extension to a Hunt Group

The identifier is your choice. Most people just label their servers 1 - N, and whichever you one you want to start with.

 

E.g.,

sccp ccm 10.1.1.10 identifier 1 ; pub
sccp ccm 10.1.1.11 identifier 2 ; sub 1
sccp ccm 10.1.1.12 identifier 3 ; sub 2
!
sccp ccm group 1
 associate ccm 3 priority 1 ; sub 2 first
 associate ccm 2 priority 2 ; sub 1 second
 associate ccm 1 priority 3 ; pub third
!

Anthony Holloway

If you found this post helpful, please consider clicking that helpful button!

And for a limited time, by marking helpful posts, you're also helping Doctors Without Borders

View solution in original post

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here