I believe in this forum there are so many engineers who solved the ATA 186 configuration. I would like to draw their attention.
ATA 186 is not registering with cucm. I am using cucm10.5. So far the document I've found is not working. It is mentioned that some fields are not same as the documents. please see the attachments of my ATA 186 device's interface.
This is very OLD firmware running on the ATA, you may need to consider upgrading the firmware manually before you attempt to register to CUCM 10.5. There are many documents on the web with directions on how to do that.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...