Similar situation here... I'd like to know is it good enough to just set
Where I can get this firmware?!
Last firmware is
|ATA 187 load signed COP file - Compatible CUCM Versions: 6.1(5)+ |
I want to assume this is a pending firmware update, since it's clearly been a while since an update was released for it.
It would really be nice if the Bug Toolkit had time/date stamps on it to document these things.
I have now installed the firmware on one of our ATA187 devices.
Can anyone confirm that the firmware will fix the issue?
Firmware name: cmterm-ata187.9-2-3-1-es9.cop, I guess its the same firmware.
Yes, I received that version this morning as well and will be pushing it out to a few devices today. I'll post my results and look forward to hearing your experience as well.
Update 1: Failing install due to MD5 checksum error. Waiting on my TAC engineer to confirm it unless you can confirm it for me.
i have the same isuue with the ATA 187 ,that keep unregistered until i do power off and power on
i have the cucm 8.5.su3 ans and the latest ATA firware 126.96.36.199
do u upgrade the ATA to the cmterm-ata187.9-2-3-1-es9.cop ?
does it solved the problem ?
can u please send the firware to me ?
my email is email@example.com
Thanks in Adavmce
Hello. I have read all the comments about this issue.
We have 100 ATAs and the problem is present in three of them. I tried with all available firmware versions (until 188.8.131.52, the last one). I tried changing Common Phone Profile by creating one specific for ATAs. Also, I used non-secure phone profile with disabled TCP. The problem is still there.
Do you (Cisco) have any permanent solution?
CUCM System version: 184.108.40.20600-12
I've been experiencing this issue for some time as well with the ATA 187. I am currently on CUCM 220.127.116.1100-26 and ATA 18.104.22.168. I haven't tried any of the suggestions on here as they all seem like things to try. I am not able to find this 9.2(3)SR1 firmware either.
Is there a known fix? Or, did everyone get together and have a ATA 187 burning without me?
Thanks Fedotov_Evgeni. It seems working for me. What I did was disable the inline power (power inline never) for the port which ATA connected and shut/no shut the port, the ATA just get registered without require to reboot the ATA.
I was able to obtain load version 9-2-3SR1-1 from TAC. I've set two of my ATAs to this firmware and will monitor to see if they become unregistered.
Was 9-2-3SR1-1 the fix for anyone? This forum is still unanswered. I will report back if this works for me.