We recently purchased a few 187s, since the tried and true 186 and the equally awesome 188s are no longer available. (I can't be the only one who loved the backplane on the 188s, why did they stop making them like these?)
I can make and place calls through the 187s but when it comes to sending and receiving faxes, both within my voip network or out of the PRIs, I get nothing. I configured the devices for fax pass-through thinking the t38 relay might have been the problem but that didn't do a thing.
I am running UCM 220.127.116.11 with MGCP gateways going through 2 X6600 CMMs in my 6509. Here is the MGCP configuration on each CMM.
mgcp call-agent 172.16.3.XXX 2427 service-type mgcp version 0.1
Can't tell re MGCP, but in my case (Xerox 7228 fax) I had to enable t38 on outgoing and disable on incoming and fix fax rate to 9600. Also there was an issue with Impedance - as it seems Cisco has default of USA, and some EU phones/faxes might need a different setting. In my case 270ohms + 750ohms || 150nF works better.
NIM-PVDM is the Next-generation digital signal processor (DSP) module with an onboard DSP daughter card which eliminates the need to procure an additional T1/E1 NIM card in order to utilize a PVDM4 chip for IP media services. This module enables the new C...
QuestionGood morning. I am looking for the equivalent of the System Manager Guide Supplement for the SS7INNIC as found on the UCCE CallRouter. Specifically, There should be a table for the EMSUserData Mapping so I can drill down on specific informati...
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...