As everybody here, I have couple of problems with my ATA 187. I have connected ATA into my network, it gets the correct IP address, I have access to it's web-interface, but it has wrong tftp address: 10.10.24.2
Along with this ATA I have couple of Cisco IP phones in the same network, and they are getting correct tftp addreses.
Can anybody help me with this question?
P.S. No idea where it learns this 10.10.. address, it was new and I don't have this subnet at my network at all.
Finally, I cracked it! The problem was with the DHCP server, it wasn't cisco and seems to me, it has some different type of option 150, so ATA 187 didn't understand it (although cisco phones are alright with it).
What you can do it this situation:
1. Perform hard reset of your ATA, throw it's built in IVR
If it wouldn't help:
2. Throw the same IVR you can configure the address of TFTP server manually.
Hope, my experience will be helpful for somebody))
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...