cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1240
Views
4
Helpful
4
Replies
Highlighted

ATA 190 - Not able to save a static IP

Good morning,

we are trying to configure an ATA190 with static IP. However is driving me crazy... it is impossible for me.

I am able to change the mode from DHCP to Static.

I enter ****

then 101 - 1

At this poing everything look good, however I am not able to do the next steps.

I enter 111

and them the IP, I have tried with all number and with dots

192.168.109.2   /192168109002

However when I enter the show ip address ivr code: 110

The IP is not there.

This is the same for the mask and the gateway.

Is there something I am missing?

Anyone have it in static mode.

Thanks in advance.

PD: The codes I use are here.

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cata/190/1_0/english/administration/guide/sip/ATA190/a190_agBcd.html

4 REPLIES 4
Highlighted

Hi,

please, try to Factory Reset the ATA 190 (code 73738) and try again.

Best regards,

Marcelo Morais

Highlighted

Hi Marcelo.

I will try it today. I will let you know if are lucky.

Thanks.

Roberto.

Highlighted

No luck, same resullt.

Highlighted

Content for Community-Ad