cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1998
Views
4
Helpful
4
Replies

ATA 190 - Not able to save a static IP

Good morning,

we are trying to configure an ATA190 with static IP. However is driving me crazy... it is impossible for me.

I am able to change the mode from DHCP to Static.

I enter ****

then 101 - 1

At this poing everything look good, however I am not able to do the next steps.

I enter 111

and them the IP, I have tried with all number and with dots

192.168.109.2   /192168109002

However when I enter the show ip address ivr code: 110

The IP is not there.

This is the same for the mask and the gateway.

Is there something I am missing?

Anyone have it in static mode.

Thanks in advance.

PD: The codes I use are here.

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cata/190/1_0/english/administration/guide/sip/ATA190/a190_agBcd.html

4 Replies 4

Hi,

please, try to Factory Reset the ATA 190 (code 73738) and try again.

Best regards,

Marcelo Morais

Hi Marcelo.

I will try it today. I will let you know if are lucky.

Thanks.

Roberto.

No luck, same resullt.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: