ATA186 (SCCP) problem dialing "*"

[Velimir Filipov]

Hello fellows,

I have a problem with ATA186 with SCCP registered to CME on 2811 voice router.

Whenever you dial asterisk "*" as the first symbol in the dial string, its just not seen by the CallManager

So if i dial *3, on the callmanager i see just 3.

But if put the asterisk on any other position, it shows up..

Has anyone encountered such issue ?

Thanks in advance.

[Velimir Filipov]

Ok, i guess i didnt provide enough info.

ATA186 (SCCP)

S/W Version     3.02.04(090202A)

H/W Version     0x0014 0x0000

Product ID     ATA186I2-A

Router is Cisco 2811

Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 15.1(2)T1, RELEASE SOFTWARE (fc1)

CONFIG (Version=8.1)

=====================

Version 8.1

Max phoneload sccp version 17

Max dspfarm sccp version 18

Cisco Unified Communications Manager Express

[Roger Kallberg · Accepted solution]

The * is per default used by the ATA186 as a trigger for pre or mid call features.

See more at this URL, http://www.cisco.com/en/US/docs/voice_ip_comm/cata/186_188/3_0/english/administration/guide/sccp/user.html

Please remember to rate all useful posts.

Sent from Cisco Technical Support iPhone App

[Velimir Filipov]

Thank you very much!

Is there any way to disable Pre-Call services, not only change the prefix for it ?

Best regards.

[Roger Kallberg]

Have you looked at this, https://supportforums.cisco.com/thread/283564

Please remember to rate all useful posts.

Sent from Cisco Technical Support iPhone App