cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

AMA-CUCM Troubleshooting: Best Practices for Reading Trace Files

55
Views
0
Helpful
1
Replies
Highlighted
Beginner

ATA190 and Motorola DECT Phone issue

Hi,

I have the problem that a DECT phone behind a ATA190 does ring poorly. The ringtone is delayed, than it stops ringing, than it starts again after 5 seconds. Than the display goes into onhook mode. When you hook off you got the call.

It seems that the ringing signal issn´t recognized correctly from the DECT phone.

Any Ideas?

1 REPLY 1
Collaborator

Cisco analogue gateways (ATA

Cisco analogue gateways (ATA & VGs) don't tend to emit the required voltage (-48V) for ringing. Many devices are quite tolerant of this bad behavior by Cisco, but occasionally you find devices (Such as your Motorola DECT base station) that are a little bit more sensitive to ringing voltage.

GTG

Please rate all helpful posts.
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards