ATAs auto register to "default" device pool but not to device pool with subs
Auto registration is turned on. The ATAs auto register to the PUB. When we configure the device to the production device pool that contains 2 subs the ATAs do not register. In addition, the ATAs (out of box) are on firmware v3.1.0. They don't upgrade firmware even when registered to the pub. There are 2 tftp servers in the network...one server dedicated to tftp and the other is the publisher. Callmanager is 7.1.3 is using default firmware ata030204sccp090202a. Even when the new firmware is placed at the device level it still does not upgrade.
I upgraded one of the ATAs using third party TFTP and was able to bring it up to the prescribed ata030204 level. It registers to the production device pools. Any ideas why ATAs don't load firmware? I checked database replication using the "show perf " command on each server and db appears good. All other IP devices register without issues. Also, restarted TFTP services on both servers.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...