cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
563
Views
0
Helpful
2
Replies

Audio Control in QSC20

Asked this in the Support Communities but thought I would hit here too.

Have a QS C20 that has been upgraded to TC 7.3.

I am trying to manage the mic levels as I can on a C40 or SX20.  When I go into the System configuration  >>  Audio, I am not seeing all of the Input Microphone options as I see on the SX20's and other units we have.

Is this because it is not seeing the mic physically connected? or is the a "feature" of the C20's?

1 Accepted Solution

Accepted Solutions

Enrico Conedera
Cisco Employee
Cisco Employee

Hello -

The C20 does not have that feature. The capability to adjust input levels was actually added to the SX20 only recently, in TC7.0.  But the C20 is lacking the capability.

View solution in original post

2 Replies 2

Enrico Conedera
Cisco Employee
Cisco Employee

Hello -

The C20 does not have that feature. The capability to adjust input levels was actually added to the SX20 only recently, in TC7.0.  But the C20 is lacking the capability.

nuts..  Thanks