cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
118
Views
0
Helpful
5
Replies

Auto Dialing/Hot Dial option in CP8800 3rd Party Call Control

Using CP-8811 for 3 party call control and registered in Broadsoft v21 sp 1

2 lines are registered on phone. Second line should be use to check the general voice mail.

Message key only dial line one voice mail number.

I want to set up ring down/Hot Dial  to dial voice portal number (9999 or *62 ) as long as pick the VM line.

 

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Auto Dialing/Hot Dial option in CP8800 3rd Party Call Control

I guess I understand what you are looking for. Change dial plan on Ext 2 to:

(P0 <:9999>)

 

This should dial out 9999 as soon as you go offhook

5 REPLIES 5
Cisco Employee

Re: Auto Dialing/Hot Dial option in CP8800 3rd Party Call Control

I am not sure if I understand your question. You want two lines registered and use the second line to dial out to just voicemail?

Re: Auto Dialing/Hot Dial option in CP8800 3rd Party Call Control

Yes, Second line just dial out the specific number (9999 or *68)  as long as go off hook.

Cisco Employee

Re: Auto Dialing/Hot Dial option in CP8800 3rd Party Call Control

You can configure second line as a speed dial to dial out 9999.

Cisco Employee

Re: Auto Dialing/Hot Dial option in CP8800 3rd Party Call Control

I guess I understand what you are looking for. Change dial plan on Ext 2 to:

(P0 <:9999>)

 

This should dial out 9999 as soon as you go offhook

Highlighted

Re: Auto Dialing/Hot Dial option in CP8800 3rd Party Call Control

This is exactly what i am looking for.
Thank you
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards