02-05-2011 02:20 AM - edited 03-16-2019 03:16 AM
Hello Experts,
I am using auto QOS in the switch level (3750) and need your help to configure the QOS in the router (3845). We have 2Mb bandwidth on the WAN side and we do video conference quite often. Could you please let me know what would the best QOS config be? Do you guys recommend CRTP?
Thanks,
MK
02-05-2011 04:56 AM
Depends on the WAN Link speed?.. Cisco recommends cRTP on slow links [768kbps and less].
Set the bandwidth of the links..and try AUTOQOS.. it usually works well.. After which you can tweak the parameters.
HTH
PS:rate useful posts.!
02-05-2011 04:59 AM
Here's a white paper on AutoQos
http://www.cisco.com/en/US/tech/tk543/tk759/technologies_white_paper09186a00801348bc.shtml
02-05-2011 05:03 AM
02-05-2011 05:13 AM
here's the QOS Guide
I would say...hardcode the Bandwidth on the interface to 2mbps and do a auto qos setup. Manually add classes/traffic types if needed after wards.
AutoQos will take care of RTP/Voice Signalling.
Auto Qos for VOIP White paper
Go through them, they will be helpful in deciding to go autoqos or not.
HTH
PS: Rate usegful posts.!
02-05-2011 05:18 AM
Thx.....
02-05-2011 05:29 AM
If your questions were answered then please mark this post as ANSWERED.
02-05-2011 08:02 AM
Here's a link with the Enterprise QOS configuration.
http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoS-SRND-Book.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide