10-22-2015 08:06 AM - edited 03-17-2019 04:39 AM
i have a cluster consists of CUCM Publisher and two CUCM Subscribers , auto registration is disabled on Publisher and enabled on Subscriber 1 and subscriber 2, also i have tow CM Groups as below :
CMGROUP1 :
subscriber 1
subscriber 2
Publisher
Auto registration Enabled.
CMGROUP2:
subscriber 2
subscriber 1
Publisher
Auto registration Disabled.
now for Auto-registration if i put subscriber 1 and subscriber 2 on NONE partition phones get extension and working fine, if i put subscriber 1 and subscriber 2 in PT-INTERNAL it is not able to get extension , please advise any got this problem before?
Solved! Go to Solution.
10-22-2015 08:59 AM
Are you sure that those extensions are not already present in your cucm database..
Use route plan report to check that these extensions range don't already exist
10-22-2015 09:17 AM
Hi there,
Just a note to add to the good ideas from my friend Deji (+5 Deji!)
Any time Auto-Registration is disabled the Partition setting for Auto-Registration DN's gets reset to "None" so I would have a look at the Partition setting on the Auto-Registration config page and change to the one you desire to use ie; PT-Internal in your case.
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/7_1_2/ccmcfg/bccm-712-cm/b02autor.html
Cheers!
Rob
10-22-2015 01:27 PM
Hi Rob (+5)..Great to catch you hear again..Long time ( I have been mostly out..). Hope you are keeping well..
10-22-2015 08:59 AM
Are you sure that those extensions are not already present in your cucm database..
Use route plan report to check that these extensions range don't already exist
10-26-2015 01:17 AM
thanks all persons , i deleted the numbers from Call routing ----> Directory Numbers , the numbers descibed as Auto, around 100 numbers Deleted , it works well.
10-26-2015 02:16 AM
Glad to know its working..Please mark the answer as correct to help others in the future
10-22-2015 09:17 AM
Hi there,
Just a note to add to the good ideas from my friend Deji (+5 Deji!)
Any time Auto-Registration is disabled the Partition setting for Auto-Registration DN's gets reset to "None" so I would have a look at the Partition setting on the Auto-Registration config page and change to the one you desire to use ie; PT-Internal in your case.
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/7_1_2/ccmcfg/bccm-712-cm/b02autor.html
Cheers!
Rob
10-22-2015 01:27 PM
Hi Rob (+5)..Great to catch you hear again..Long time ( I have been mostly out..). Hope you are keeping well..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide