04-20-2007 06:46 AM - edited 03-14-2019 09:05 PM
Hello , I need a example for configure two 3640 back to back with fxs to fxo. voip-a---3640-fxs-fxo-3640--voip-b. My problem is when call from voip-a to the voip-b , and recive disconnect from voip-b , in the voip-a hear ringback all time
04-20-2007 07:08 AM
This is typical of fxo/fxs. Look at:
http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
on CCO.
Try configuring both ports for ground start or another disconnection supervision as explained in the document.
04-20-2007 07:34 AM
I see this later but I have loop-start configured .
Need change to Ground?
04-20-2007 08:02 AM
Have you read the document? It will explain you why without supervision your lines are going to remain stuck all the time. So, either ground-start, or other disconnection supervision must be configured.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: