Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hey,Any help regarding this issue will be greatly appreciatedI set the ringtone on all extensions to chrip as the default sunrise is to soft to hear in our work environment and calls get missed. Within the week the ringtone will have reverted back to...
Dear,We are facing some issues when collect calls are placed to a Cisco Voice Gateway with a E1-R2 link. There are some disconect causes 91 that i dont know what it means. Could you help me?Thanks!debug vpm signalJan 22 16:19:14.937: htsp_process_eve...
Hi, all, I've havving problems with mi E1 R2_Digital voice port, the problem is that the calls cannot go in, but calls from IP Phones to PSTN can go out,I wrote some debugs commands, with this error on the VMP command.Jan 3 17:46:26.643: R2 Incoming...
How to unlock cisco 7911 for manual network configuration changes?
Since moving to our Cisco phone solution, we've been plagued by accidental 911 calls. When the users do this, they hang up and the cops show up. We've tried counseling the users but in the end I feel like this is something we should be able to prev...
I have probably deployed about 80 7960 IP phones. Over time, about 10 or 12 of these have been RMA'd because suddenly the footstand just fails and will not latch into place, it just goes completely floppy. I can say with almost complete certainty tha...
Hello guys ,I want to know what's the recording options for CME. Does CUCM have a built in recording system or what not.Thanks.
Dears;can I configure Avaya K175 Model (K175D02A), as 3rd party SIP.Avaya K175 with loaded firmware (K1xx_SIP-R2_2_0_6).46xxsettings.txt configured as follows:SET SIPDOMAIN (CUCM DOMAIN)SET SIP_CONTROLLER_LIST (CUCM_Server_IP):5060;transport=tcpSET ...
This morning when we came into the office, several phones are stuck in VPN mode, not sure what happened last night, they were fine day before yesterday. All phones are impacted, most are 8XXX series. We tried reboot on one of the phone initially and ...
Hey guys,I want to to intergrate cisco voip CME with issabel , does anyone know how to make it ?
have setup direct routing recently with CUBE .. My ITSP (in Australia) appears to accept alaw as 1st preference followed only by ulaw as 2nd choice before sending 180 ringing back ... What I noticed is if i call an external number from Jabber registe...
Can i connect issabel with cisco cme sccp phone ? if I can't, what is the best recording option for cme ?
Am I missing something, or is there a bug (IOS 15.7(3)M8) which would seem to make the following combination of commands totally incompatible?I have tried with separate inbound/outbound dial peers, and even wiping the whole config down to a single di...
Hi,is there a way to enable mobility for all users bulk other than using cucm , And second question for a remote destination profile for snr requires any type of license Thanks
Hi all I am hoping to setup a callback function using Cisco Unity Connection version 10. In this, a user would call a number. The system should prompt for a message. A message is recorded. The user hangs up. The system uses the users cal...
