Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
CUCM 12.5 rookie here.My SIP provider recently implemented E.164 and now I am no longer receiving inbound calls (outbound still working). Example: they were sending 01135319041234 and now I am receiving +35319041234. What items do I need to update?Iv...
Hello everyone,Is it somehow possible to use these phones with Cisco UCM 11.5?Could not find any precise answer on the web
After a lot of trouble shooting I have discovered that I can get an Cisco 8851 to drop the network connection right after I press the Sleep key on the keyboard. This is becoming a problem as because if the computer sleeps for too long the phone will ...
Hello,I have an ISR 2911 with the IOS 15.3(3)M5. This gateway is configured to allow SIP Phones to register in case of a CUCM failure using the eSRST mode.Here is the configuration:voice register global mode esrst system message "Mode SRST" max-dn 20...
Dear All, I would like to use the new-ish CUBE multivrf feature (documented here). One of the limitations is: Multi-VRF is not supported on TDM-SIP gateway What is actually meant by this? If I wanted to run say an MGCP controlled NIM-4FXS on the sa...
So i was given some new 6945 phones to add to our existing phones in the router ISR 4331 with"Cisco IOS XE Software, Version 03.15.03.S - Standard Support Release" ,"Cisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.5(2)S...
I am configuring dial-peer targets as a group using voice class server-group. I am also trying to monitor the status of the targets with the voice class sip-options-keepalive option for all applicable dial peers. When I check the status of the dial...
is this topology is right, or i have to change it based on this:
can anyone check my topology based on thisAlpha Financial Services is a growing f
I know there are several posts about this, but I've not seen any proper solutions. Just a couple of half work arounds.I'm using the latest sip88xx.14-2-1-0201-40 firmware and have the phone connected to my Asterisk / FreePBX server, so I'm modifying ...
I am working with a network phone system running CUCM 10, alongside CER and some other similar systems. Inside the phone network, calls to 911 are failing. The caller gets a rapid busy signal when they try. I can see the attempts in the CER call hist...
Hi Guys, I am hoping someone can shed some lights on an issue I am experiencing with VG202 port configuration. We have an intercom system which dials a pre programmed number (Cisco IP phone). The intercom Exchange line interface module is plugged int...
Hi,cucm -sip trunk -sbc(ribbon) -msteam 5785cucm -phone 5785cucm-phone 5786calling number 5786called number 5785If I want to ring both 5785 same time ,what is the option in cucmThanks
Hello, We are having a strange problem our Call Manager is ver 14 and we have a mixture of 7941 and 8811 phones. This has been this way for at least a year this week some of the 7941 phones began experiencing static , bad quality , r...
Does anyone know of a table like this for all Cisco phones? I started putting such a table together but it's turning out to be a lot of work. And a lot of the current phones don't have EOX dates, so I would need to watch for updates somehow. ...
