IP Telephony and Phones

Hello Community I'm trying to setup an incoming SIP trunk with one ISP and I'm seeing all the INVITE messages, but my 2921 is not responding back :( below is my relevant configuration, any advice is welcome. Basically I want to receive calls with dia...

I've been looking over several CSC posts and guides on this, but still can't seem to get it working.  I have a Hunt Pilot setup with line groups and everything is working great, but I now want to introduce a time schedule so outside of regular workin...

The majority of our Cisco SPA508G phones started displaying the attached "Forwarded to A10" message and we haven't been able to figure out why, anyone have any suggestions?

Are there any updates to the release date of CE8 or a similar software release for the DX Series, specifically the DX80 and DX70?  I see the Cisco site still only has 10.2(5.194)ES listed as the latest version available.  Thanks

I have some 7841 phones that at first have no admin password needed.  I am defaulting the phone, letting it connect to our system, and after it does so it needs an admin password Cisco. I can see in the XML that it is listed under phonepassword as Ci...

Hi. I have a CME version 9.1 with a problem to translation a called number. The configurations are below: ------------------------- voice translation-rule 1   rule 1 /^00../ /025/ voice translation-rule 2  rule 1 /^.*/ /6133222222/ voice translati...

Hi, I have a user requesting to have entered digits displayed on screen during an active call. The typical scenario is the user calls a Call Center. The Call Center script asks the caller to enter various user inputs (account numbers, date of birth, ...

Can an 8851 be programmed to force the user to enter a code in order to call forward a line? Customer is trying to prevent someone from inadvertently forwarding a line

Hi Team, I have a problem with IP phones "various models", in the status messages a message appears constantly showing "SEP [MAC] .cnf.xml" as shown in the following capture. I connected to a 7961 and I downloaded the logs, when I check them I se...

Hello, I'm stuck with locale problem on 7962G phones. There are several 7962G controlled by UCM 10.5.2 and one of them can not install Russian locale. In status messages i see "Error Updating Locale" message. The only difference between the same phon...

Hi, Im sooooo newbie. I want to change the codecs of the CUCM to use, by default G.729 or G.722. CUCM Version  10.5.2.13900-12 All phones in the company are Cisco 6921. Thanks :)

I am running cme 11.5 with 7841 SIP phones.  A wireshark capture shows RTP streams going through the CME router and not directly between phones.  Is this normal?  Should I see RTP chatter between two SIP phones ? AT