IP Telephony and Phones

Hello, Does anyone know if the Plantronics Savi 700 W720- M headset with the EHS Cable Apu-72 can it work with Cisco 8831 series. What I am trying to do is have the headset connected to my pc using USB for skype calls but yet also have my headset co...

Is there a way to bulk import a phone book to Cisco 7925 wireless phones? Currently we do it one by one which is just a nuisance. Have hundreds of these phones and would like to be able to do them all at once and make sure they all have the same addr...

Hi,I currently came across a request for the RM license for SX20.Looking up on supportforums and other websites, I learned that for already deployed Sx20s, Cisco licensing will help with getting the RM license at no cost for them.My questions are:1. ...

Hello, I have a cucm version 11.0.1.20000-2 , with ip phone 7861(firmware sip78xx.11-0-1-11) registred in this version. the problem is the ip phone is very slow . I verified their informations ethernet and port , i found That these values are very...

Ear and Mouth with 4 port network interface module was acceptable only with some countries? How many ports used for calls and what about signaling? Is it similar to ISDN BRI? If E & M port is inserted with voice gateway what is the dependency of DS...

Hi all, I have a lot of problems with cisco 2911 with IOS: c2900-universalk9-mz.SPA.152-4.M5 in FXS port.I don't have dial tone in FXS port, always busy. I configured the port as stcapp, Incoming calls works ok,  but there is no dial tone. I done upg...

Hello CSC; I'm having an issue with a SRST configuration with a PRI connected to it. For incoming calls, I dial a 10 digit number 9055556589 but when I do a debug isdn q931 I see the 'Called Party Number' as only the last five digits so that would b...

I have a customer with a Dell powerconnect 5548P switch.  It is a POE switch, 802.3AF compliant switch.  The KEM module never gets powered.  Does anyone have this switch and did you have to buy a power brick for the KEM module? Cisco's documentation ...

transcoder and MTP not registering in CUCM. below is the configuration in gateway . transcoder configured as Cisco IOS Enhanced Media Termination Point in cucm (pvdm3). checked access to port 2000 from our end . !sccp local GigabitEthernet0/1sccp cc...

I just need help with the Diversion header for FORWARDED calls. Using SIP profile 101, the original Diversion header is stripped and replaced with the prefix. This is a single number reach scenario. voice class sip-profiles 101request INVITE sip-he...

I have a problem that I think can only be solved by my carrier, but I wanted to post here just in case I am missing something. Here is the (made-up) example: I have a 10.5 CUCM/CUBE system in Portland with numbers in the 458 area code. When I recei...

I got everything working with CTI route but when the user signs into jabber and tries to forward/unforward calls from there its empty. How can I set it up so he can use jabber to control that?