IP Telephony and Phones

Hi TeamI have been asked a question by one of my clients. the new DX 650 series IP Phones have a built in HDMI port that can connect to an external monitor. My client wants to know that if he has a video call on his DX650 can he have the same display...

Hi all,There was a building shutdown in my office and i shutdown both my publisher and subscriber.Now the corporate directory on all my cisco phones are not working with error "Host not found"I did a restart of TFTP and TVS services but it didnt help...

7941 Phones have SCCP41.9-4-2SR1-1S firmware. New SCCP41.9-4-2SR2-2S firmware is uploaded, tftp service is restarted.Only factory default reset provide firmware upgrade. We have a lot of such phones and manually upgrade is not option. With old firmwa...

Hello, I have a CUCM v11. The problem is:   concern call to INTERNATIONAL destinations if one dials the number by lifting the handset or in speakerphone mode. A voice message of the operator is issued without allowing us to dial the entire number....

Dears, i am installing cucm 11.5.1-11900 on a VM on BE6000M, the installation is interrupted with rpm issue. find attached the error. any idea plz? best regards, chawki dib

Hi,  I have been asked by an end user if there is a way to cancel voice mail using an app applied to CUCM and a phone SKT. I think they have VM, CFB and CFNA for all users; however, some users want the ability to turn this off and on as and when they...

Hi all Please could somebody give me some advice. I have been asked if we can translate a call differently from different people. example Existing Translation Pattern  is 333. rule is discard predot prefix digits outgoing nnnn00002 nnnn00002 just c...

Hi , I have C2901-CME-SRST/K9 and i need help to configure it to work with DX650, CP-8851, CP-8831, CP-7861 please.

Hello I am trying to setup a 7961G VoIP as an anonymous phone line that people can call for help and would like to know if there is anyway in CUCM or on the phone itself to hide incoming numbers from showing on the screen.  If this is possible please...

Dear, I want to enable auto-attendant in my router 2811 on interface "voice-port 0/3/1" but it does not work please help me. detail as below applicationservice queue flash:app-b-acd-3.0.0.2.tclparam queue-len 15param aa-hunt1 6100param aa-hunt10 10...

Hi Team, I was implemented CUC-to-CUCM with SIP trunk last two month back, its working voice messaging system. when i was dial to voice profile no its working its says play IVR message and ask PIN no. Now we are observe the one issue. when i have pre...

We have been ordering VG 350's with a PVDM3-256 and VG310's with a PVDM3-64. We use VG350 primarily for Faxing, modems and analog phones. Are PVDM's a prerequisite to run Analog sets and faxing on VG350/VG310 ? Could we configure the pvdm3-256 on VG3...