Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello there, in a scenario, assume that a Cucm wants to connect to third party ip-pbx which is H323 & SIP enabled. Both the cucm server and pbx are in the same LAN network. Now the question is that if it is necessary to set voice configuration on ro...
Hi,I need some support from you guys. I'm planning to upgrade the current CUCM 7.1.5 to CUCM 9.0, however i couldn't locate any resources that show the exact procedure for this. The CUCM 7.1 is running on MCS server, and we're going to upgrade to UCS...
HI All, Facing a strange issue for Vg 224 gateway connected the analog polycom phone whenever we are trying to make a call we are getting a fast busy tone and not able to make any outgoing calls internally and externally. As per the call flow: P...
Hi, We have a bunch of CUCM clusters (originally on v8.6) that communicate for internal calls with gatekeeper controlled trunks. On the core we have 2 gatekeepers on HA (Cisco 3925). Now we´re upgrading our clusters to v10.5, and there are appearing ...
I am entering "sh call active voice brief" command In the output...somewhere it shows Answer & some where Originate I this means "Answer" -> Received call "Originate" -> dialed a number
Dear Sir, I have a CME Router That Work as my VoiceGateway. and now I want to take all my internet Connection on it but the problem is that before that I do this one time and someone hack my telephony Router and make a big bill for me to pay. I want ...
Hi, We have a CUCM10.5 cluster with a sip trunk to a small CCME10.5 deployment running on a 2951 router. We use a route pattern match on the CUCM side to send calls over the SIP trunk to the CCME as required. There is also a dial peer on the CCME si...
Hi, Should I enable & use the isac & opac codes on my VoIP environment?
Hi, I want to show call waiting via visual or audio alert, ex :- if i'm calling to an extension and that user is on another call and I should get an alert (visual or audio) that user is on another call. is it possible? Thanks, Rajitha
IP phone are registered while fallback, but our wireless phone are not registered when link fails. Our scenerio is like DC center having wireless controller , CUCM cluster & remote sites having Voice Router & AP's are connected. When WAN link fails ...
Hi There, I am trying to register few 7821 SIP Phones without a DN on it. The should only subscribed to EM functionality. The 7821 are already created. Can someone provide me some information, if it is possible in CUCM 10.X ? Thanks VS
i received a new 2900 cisco router and im suppose to upgrade from my old 2801 cisco router , Im wondering can i simply copy paste the configuration and just check for the new ethernet port number to connect to my network and it will work like the old...
Hi All, I came across an issue where users are not able to dial 800 toll free numbers. They are using CME and sip trunk to provider. when they are dialling 0800XXXXXXX getting busy signal not connecting. for test, we tried calling 8001248888 fr...
Hi experts, I have problem with incoming calls issue on 2921 Series CME , out going calls are fine. Please find the configuration and logs below appreciate your support. ------configuration ------ !!voice-port 0/0/0:15 bearer-cap Speech ! ! ! !...
Hello there, In am wondering if there is any switch or registry setting that will bring up Preferences screen first on CIPC startup. Dealing with many different customers I am trying to avoid waiting for CIPC to fully launch before changing TFTP serv...
