IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Cisco 7811 CUCM 10.5

Hi AllI have a CUCM and i'm trying to add a 7811 ip hone, but in the listing devices the 7811 does not appear, i was installed le package cmterm-78xx.10-3-1-12.k3.cop.sgn, but the result was the sameThanks....

juankcs85 by Beginner
  • 4 replies
  • 0 Helpful votes

Unity broadcast message

I was reading the documetation on Unity 8.x broadcast messages.After setting this up, does the broadcast message do the entire system or can the broadcast messages be sent to a distribution list, and controlled by users? I have specific location that...

Resolved! h323 gateways in a routelist

I have two H323 gateways in a route list that 911 is pointed to in the CUCM for a location. vgw1-rg1vgw2-rg2 On vgw1 911 is a trunk group of pots lines that 911 goes out over the 911 dial-peer, and on vgw2 911 is configured to go out over 911 dial-pe...

speed dial for 7821 on CME

Dear,I have phone 7821 registered with CME . I configured speed dial !voice register pool  2 busy-trigger-per-button 1 id mac C472.95A9.985E type 7821 number 1 dn 2 dtmf-relay sip-notify username 2 password 1111 codec g711ulaw no vad speed-dial 1 224...