Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
are you aware of any adapter like this one? VEC TRX-20 3.5MM Direct Connect Telephone Record Device that will work with the 8800s phones the adaptor works with 7900 phones thanks
I'm getting an issue in fxo lines in the isr. Found in vpm signal log about "fxols_power_denial_detected" on outbound call.Also, ring detection is shown on show voice port summary on inbound call. I added the command no battery reversal and no superv...
HiI have a CUCM cluster and I need to update some phones. Normally I can do that Update Phones / Query. Or I can use BATI have used BAT a lot, but normally to insert phones/user or to modify somethingI have now the scenario that I have to set a Calli...
Hello,We recently switched to Microsoft Teams as a calling service. We had to factory reset all of our Cisco 8861 phones to add in the Microsoft provisioning server. Everything is working on the phones except for the time at the top. When we first bo...
In our primary cucm server all registered phones not showing call history from before two days. What could be the problem and what should we do for resolving this issue
Is there a way to have CUCM add 91 in from of 10 digit missed numbers?To return a missed call it seems user have to used the EditDial soft key to add the 91 in from of the 10 digits?It doesn't look to me like there's a Dial Rule option What is the "D...
Is there a way to check through sql query regarding the number of voicemail messages a user got in a day?
Hi Guys, We are migrating form an E1 to a SIP trunk with Dutche Telkom as the provider. I have inbound and outbound calls working. We are facing an issue with call forward to an outside line. Call Flow SIP Provider -> CUBE-> CUCM -> IP Phone -> Call ...
Is there a way to configure a Dial Rule or some other setting that would allow users to return calls to 10 digit numbers and have the system automatically add 91 in front of the number?Currently, if we select a missed call number and press call, it s...
Hello,Is there a way that Cisco Jabber can be automatically started on a ios or Android device after a reboot? Brian
Hi All, I have cisco Cisco 8851 phone which has BEKEM 36 button line expansion module, phone is registered but it is not powering up.Troubleshooting Done:Phone Button Template: It supports expansion moduleExpansion module : Set for BEKEM 36 button li...
Hello, I am trying to find a place under device in CCUM for key expansion module and dont see it. I am sure it is just fine and probably needs to be activated - my guess. Thank you,
Hello,I try to block some calls on the incoming dial-peer but have to translate 1 special number.+4930123450 => translate to +493012345999+493012345 + 2 digits => reject+493012345 + 1 digit => reject !!!Here is my config dial-peer voice 1 voipdescrip...
Hello, We currently use 7841 and 8851 phones with APC-43 EHS adapters to Plantronics CS540 headsets. Is there a way to turn off the ringer in the headset but keep the ringer on the phone. We have users at a registration intake that often have to spea...
Hi everybody We run call center at work which is using a hunt group. They need to move to another location in the building but they are no longer able to forward calls from the outside main number as they used to (inside extension forwarding works fi...
| User | Count |
|---|---|
| 7 | |
| 4 | |
| 2 | |
| 2 | |
| 1 |
.jpg "VIP Expert"){kind=icon}
