IP Telephony and Phones

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi, I have a cucm 10.5.1.11901-1 and 20 numbers of Dx-650 ip phones. All phones are working with same phone firmware. Among them one is restarting when we enter the PIN number to place the call. But can receive the call. Regards

abeebvm by Level 1
  • 178 Views
  • 1 replies
  • 0 Helpful votes

Hi there, I've got a quick question about SIP trunk between CUCM and GW. My GW has both QSIG and PSTN (ISDN PRI) access. What should I do regarding the "Tunneled Protocol" on CUCM side ? Can I use the same trunk for both access with this parameter s...

I managed to initiate calls by the protocol handlers (e.g. tel:+491511232323423) so Jabber dials the number for me on windows... but for dialing into our seamless communication platform with the respective conference numbers (e.g. "777888999#") On va...

xdohrmann by Level 1
  • 203 Views
  • 1 replies
  • 0 Helpful votes

Hi,  I have a customer with CME/CUE that has forgotten the CUE username/password. I have followed the password recovery procedure but without success http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unity-express/64234-cue-gui-p...

Dears ,        I have a strange issue regarding to calls through sip trunk configured on CME and remote site with CUCM , When iam trying make an internal call XXXX from my site to the remote site from phone 7821 , the call is working fine but whan i...

Hi We have a problem that when an user want to perform a blind transfer (thats means press transfer 2 times in a row) after press transfer the second time the call cut  and transfer can't be completed. CUCM is 10.5.2 User's phone is 7962 using SCCP. ...

Hello all,We have been working on a case with TAC engineer for more than a month now and absolutely fed up with engineer support. Every time engineer request for debugs logs and then disappeared for weeks. On sending emails and asking for status ther...